High Temp Sump PumpINSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONSINSTRUCTION MANUALIM249
10NOTES
BELL & GOSSETT LIMITED WARRANTYThis warranty applies to all water systems pumps manufactured by Bell & Gossett.Any part or parts found to be d
2Owner’s InformationPump Model Number: Pump Serial Number:Control Model Number:Dealer:Dealer Phone No.Date of Purchase: Installation:Cur
301020304050607080GPM00101002030m3/hr51040METERS FEETTOTAL DYNAMIC HEADCAPACITYMODEL: WEHT03xxMSIZE: 2" DischargeRPM: 1750HP: .33 HPSOLIDS: 3/4
4To check the seal housing oil level, where used, lay the unit on its side with the fill plug at 12 o’clock. Remove the plug. The oil should be within
5wastewater pumps contain on-winding overloads, unless noted on the pump nameplate. See Figure 1.SINGLE PHASE CONTROL PANELS:Control panels are avail
6Place Control Panel switch(es) in Automatic position and thoroughly test the operation of the ON, OFF, and Alarm floats by filling the wetwell with cle
7INSULATION RESISTANCE READINGSNormal Ohm and Megohm Values between all leads and ground Condition of Motor and Leads Ohm Value Megohm Value A new
8TROUBLESHOOTINGFAILURE TO DISCONNECT AND LOCKOUT ELECTRICAL POWER BEFORE ATTEMPTING ANY SERVICE CAN CAUSE SHOCK, BURNS OR DEATH.SY
9TYPICAL INSTALLATIONSTypical Effluent, Sewage and Dewatering Pump Installations
Comentários a estes Manuais